By default, what is the OSPF cost for any link with a bandwidth of 100 Mb/s or greater? ◾100 ◾100000000 ◾1 ◾10000 ​ 기본적으로 대역폭이 100Mb/s 이상인 링크의 OSPF 비용은 얼마인가? ◾100 ◾100000000 ◾1* ◾10000 ​ Which command will verify that a router that is running OSPFv3 has formed an adjacency with other routers in its OSPF area? ◾show ipv6 interface brief ◾show ipv6 ospf neighbor ◾show ipv6 route ospf ◾show running..

In which scenario will the use of EIGRP automatic summarization cause inconsistent routing in a network? ◾when the routers in an IPv4 network have mismatching EIGRP AS numbers ◾when the routers in an IPv4 network are connected to discontiguous networks with automatic summarization enabled ◾when there is no adjacency that is established between neighboring routers ◾when there is no common subnet ..

Refer to the exhibit. Which two networks contain feasible successors? (Choose two.) ◾10.44.100.252 ◾10.44.101.252 ◾192.168.71.0 ◾192.168.51.0 ◾10.44.104.253 ' 전시를 참조하십시오. 실현 가능한 후계자가 포함된 두 네트워크는 무엇인가? (2개 선택) ◾10.44.100.252* ◾10.44.101.252 ◾192.168.71.0* ◾192.168.51.0 ◾10.44.104.253 ​ Which three metric weights are set to zero by default when costs in EIGRP are being calculated? (Choose three.) ..

Which routing protocol is designed to use areas to scale large hierarchical networks? ◾RIP ◾OSPF ◾EIGRP ◾BGP ​ 대규모 계층적 네트워크를 확장하기 위해 영역을 사용하도록 설계된 라우팅 프로토콜은? ◾RIP ◾OSPF* ◾EIGRP ◾BGP ​ Which routing protocol uses link-state information to build a map of the topology for computing the best path to each destination network? ◾RIP ◾RIPng ◾OSPF ◾EIGRP ​ 각 대상 네트워크에 대한 최상의 경로를 계산하기 위한 토폴로지 맵을 구축하기 위해 링크..

Refer to the exhibit. Based on the command output shown, what is the status of the EtherChannel? ​ ​ ◾The EtherChannel is dynamic and is using ports Fa0/10 and Fa0/11 as passive ports. ◾The EtherChannel is down as evidenced by the protocol field being empty. ◾The EtherChannel is partially functional as indicated by the P flags for the FastEthernet ports. ◾The EtherChannel is in use and functiona..

What happens to runt frames received by a Cisco Ethernet switch? ◦The frame is dropped. ◦The frame is returned to the originating network device. ◦The frame is broadcast to all other devices on the same network. ◦The frame is sent to the default gateway. ​ Cisco 이더넷 스위치에서 수신한 런트 프레임은 어떻게 되는가? ◦The frame is dropped.* ◦The frame is returned to the originating network device. ◦The frame is broadcas..

What is contained in the trailer of a data-link frame? logical address physical address data error detection 데이터 링크 프레임의 트레일러에 포함된 내용은? 논리 주소 물리 주소 데이터. 오류 감지* Which method of data transfer allows information to be sent and received at the same time? full duplex half duplex multiplex simplex 어떤 데이터 전송 방법으로 정보를 동시에 주고받을 수 있는가? 풀 듀플렉스* 하프 듀플렉스 멀티플렉스 심플렉스 ​ Which statement describes an extended sta..

What method can be used by two computers to ensure that packets are not dropped because too much data is being sent too quickly? ◾encapsulation ◾flow control ◾access method ◾response timeout ​ 너무 많은 데이터가 너무 빨리 전송되고 있기 때문에 패킷이 손실되지 않도록 하기 위해 두 대의 컴퓨터에서 사용할 수 있는 방법은 무엇인가? ◾encapsulation ◾흐름 제어* ◾접근법 ◾응답시간 초과 ​ What type of communication will send a message to all devices on a local area network? ◾..